Most Campbell Scientific sensors are available as an –L, which indicates a user-specified cable length.
For example, the HC2S3-L has a –C cable termination option for connecting it to a CS110 instead of offering an HC2S3-LC model. Note: As newer products are added to our inventory, typically, we will list multiple cable termination options under a single sensor model rather than creating multiple model numbers. For example, the 034B is offered as the 034B-ET, 034B-ETM, 034B-LC, 034B-LQ, and 034B-QD.Īll of the other cable termination options, if available, are listed on the Ordering information area of the sensor product page under “Cable Termination Options.” For example, the 034B-L Wind Set is offered with the –CWS, –PT, and –PW options, as shown in the Ordering information area of the 034B-L product page. If a sensor is offered in an –ET, –ETM, –LC, –LQ, or –QD version, that option’s availability is reflected in the sensor model number. The options available for a particular sensor can be checked by looking in two places in the Ordering information area of the sensor product page: Not every sensor has different cable termination options. The allowed limits for this test assure that the temperature influence on the calibration is within the specified limit. After run-in, bearing friction is tested at -15☌ and at room temperature. All units are run-in for 225 hours at 9 ms -1, in order to reduce the initial bearing friction to a level close to the steady state value. Variation among units designates the maximum deviation of any unit from the straight line representing these mean values. The specified offset and gain figures represent the mean values of these calibrations. The specifications are based on 80 wind tunnel calibrations performed according to the Measnet Cup Anemometer Calibration Procedure.
0 kommentar(er)
